Install OmaBroadcast

Guide

Audio mixer

Every sound going into the recording and stream, with how loud it is and controls to change it.

Where it is

Right, under Source settings

What you can do

  • The mixer shows only the sound you add. Click + in Sources and choose your microphone by its name, or Desktop sound for the computer's sound. A camera brings only its picture; its microphone is in that list too.
  • X on a Desktop, Microphone or Sound for every studio strip removes that sound, and it stops being captured. For anything else, right-click it in Sources and choose Remove.
  • The meters: green is good, yellow is loud, red is too loud and will distort.
  • The slider and the dB box set the level. The speaker mutes.
  • The waveform button opens a strip's audio filters; it says FX when the meters run up and down.

More

  • The sliders button opens a strip's settings: monitoring, mono, balance, sync offset, which recording tracks it goes to, and push-to-talk.
  • Monitoring lets you hear a strip in your headphones: choose the output under Monitoring output at the bottom, then turn on monitoring in the strip's settings. Solo hears one strip alone.
  • + in Sources โ†’ Sound for every studio adds microphones or outputs that stay in every studio. Channels shows strips you hid.
  • Meters sets sample or true peak, how fast the meters fall, and whether strips run across or up and down.
  • Active sources only hides strips for sources not in the studio on air.

See also

In this film

  1. Green, yellow, redLoud parts reach yellow. Red is too loud
  2. Move the slider, or type a levelIn decibels: 0 leaves the sound as it is
  3. Filters on a soundNoise suppression, compressor, gate, and more